Break in a new wood stove by lighting a few small fires, each a little hotter than the last. Let the stove cool completely between them. The fires cure the high-temperature paint, drive off residual moisture and let the metal settle without thermal shock. Most manufacturers specify two to four fires, and many specify three. Follow your manual’s schedule, because the exact temperatures differ by model.
Before the first fire
- Remove labels, manuals, packing and shipping brackets from the firebox and ash pan.
- Check that the baffle and firebricks are seated correctly. They can shift in shipping.
- Test your carbon monoxide alarm.
- Open windows and doors, and run a fan.
- Keep pets, especially birds, and anyone sensitive to fumes out of the room.
- Never burn trash, cardboard or packaging in the new stove.
The three-fire schedule
- Fire 1 (small kindling fire). Use a handful of dry kindling and newspaper, with the primary air fully open. Keep the stovetop low, around 200 to 300°F, for roughly 20 minutes to an hour. Sources differ on the exact figures, so use your manual’s numbers. Let the fire die out and the stove cool completely.
- Fire 2 (moderate fire). Add a couple of small splits, about 2 to 3 inches thick, and bring the stovetop to roughly 300 to 500°F. Let it burn down and cool completely.
- Fire 3 (full curing fire). Build a larger fire with seasoned splits and bring the stovetop to about 500 to 600°F. This cycle finishes the paint cure. Let it cool, and the stove is ready for normal use.
Use dry wood, at 20% moisture or less, from the first fire. A magnetic stovetop thermometer helps you track temperatures so you don’t overheat the stove during these cycles.
What you will smell and see
Paint odor and light smoke are normal during the first one to three fires, and sometimes longer. Open windows and run fans. Don’t touch painted surfaces while they cure, because the paint stays soft until it is fully cured.
Cast iron, steel and soapstone
Cast iron should be brought up to temperature gradually, to seat its joints and avoid thermal shock. Steel stoves need a break-in too, despite the common belief that it applies only to cast iron. Soapstone stoves need a gentler break-in over several small fires, because trapped moisture can crack the stone.
Catalytic stoves
Follow the manual’s light-off procedure from the first fire. Avoid burning paper, packing material or trash, which can damage the catalyst. For how catalytic designs work, see catalytic vs non-catalytic wood stoves.
After break-in
- Check the gaskets with the dollar-bill test, and retighten the handles if needed.
- Keep burning seasoned wood, at 20% moisture or less.
- Watch the stovetop temperature against the limit in the manual.
If you have trouble keeping the fire going after break-in, see why your wood stove keeps going out.
Common misconceptions
- “Burn it hot right away to cure it faster.” That risks cracking, warping and blistered paint.
- “The smell means something’s wrong.” Paint off-gassing is expected during curing.
- “Break-in only applies to cast iron.” Steel and soapstone stoves need it too.
- “One fire is enough.” Most manufacturers specify several.