Shiplap adds texture above or around a fireplace, but wood and MDF are combustible. That changes where it can go, so plan the clearance zone before you cut the first board.
Clearances before the first board
Wood and MDF shiplap are combustible. For a masonry fireplace, keep them at least 6 inches from the opening. Within 12 inches of the opening, trim can project no more than 1/8 inch for every inch of distance from the opening.
Prefab and gas units have their own rules, so follow the manual’s combustible-facing clearances. Fill the clearance zone with a noncombustible finish, such as tile, stone, metal or cement board with a tile or stone face. If you want the look of wood nearby, fiber-cement or metal plank panels are noncombustible options, though availability varies.
Two common assumptions don’t hold. Fire-retardant paint doesn’t make shiplap safe inside the clearance zone. Drywall behind the shiplap doesn’t make the shiplap noncombustible. Don’t run shiplap right to the edge of a gas fireplace either, unless the manual allows it.
Choose boards and acclimate them
Common choices are nominal 1x6 or 1x8 pine or MDF boards, or 1/4-inch plywood ripped into strips. Solid wood should acclimate indoors for 48 to 72 hours before you install it.
Pre-paint the boards before installing them. That way, if the wood shrinks a little, the gaps won’t reveal bare wood.
Find studs and set the first board level
Mark the studs on the wall. On masonry, fasten 1x3 or 1x4 furring strips with masonry screws, then attach the shiplap to the furring.
Set a level first board, and check it. Don’t trust the floor, the ceiling or the mantel to be level, because many houses aren’t. Vertical shiplap needs horizontal blocking or furring behind it.
Stagger the end joints, and land the joints on studs so each board has solid backing.
Spacing and fastening
Leave a nickel-width gap of about 1/16 inch, or use 1/8-inch spacers. Rabbeted shiplap sets its own gap.
Fasten each board with 18-gauge brads or 15-gauge finish nails, two per stud. The nails should reach about 1 inch into the stud. For MDF and plywood, construction adhesive adds hold.
Finish: nail holes, caulk, primer and paint
Fill the nail holes, and sand the filler smooth. Caulk the inside corners and the trim joints. Don’t caulk the gaps between boards, since that defeats the look. Seal any knots with shellac primer before painting.
Apply two coats of satin or semi-gloss paint.
Safety before you start
If the fireplace is gas, turn off the gas and let the unit cool before you work nearby. Check for wiring before you nail into the wall, and use a stud finder or a wire detector before each fastener.
For noncombustible tile and stone inside the clearance zone, see brick fireplace makeover ideas. For framed wood surrounds, see DIY fireplace surround plans.