A corner fireplace is easy to overlook and hard to live with. It can cut into the room’s layout, especially when it sits next to a window or a long blank wall. A makeover can help by building out the wall and giving the fire a finished surround. The right approach depends on whether the unit is masonry or prefab.
Identify the unit: masonry or prefab
Many corner fireplaces are factory-built (prefab). Check the rating plate and the manual for the clearances and the rules for any changes. A masonry corner fireplace follows the usual masonry rules: no combustibles within 6 inches of the opening, and any trim within 12 inches can project no more than 1/8 inch for every inch of distance.
Prefab units have their own limits. Don’t block the louvers, don’t remove the hood, and don’t tile over the metal face without the manufacturer’s approval.
Build out an overmantel
Many older corner fireplaces have no overmantel, so the fireplace stops halfway up the wall and looks unfinished. Framing an overmantel gives the fire a complete look, and it can hold a TV, art or a mirror.
Fasten the frame to the wall studs and the ceiling, and into the existing framing around the fireplace box. Keep the framing clear of the flue and any vent, and follow the listed clearances for the unit.
Frame a flat wall for a bigger focal point
A corner fireplace can be built out into a flat wall across the corner. That gives you a larger focal wall, and space for niches or storage. Keep the bump-out small if floor space matters to you, since a deep build-out takes room from the rest of the layout.
Finishes: tile, moulding, paint and cladding
Common makeovers include painting or limewashing the brick, tiling the face, running cladding floor to ceiling, adding a new mantel and switching to black doors. One homeowner who renovated a corner fireplace used white painted moulding around the opening, marble picket tile in the surround and white vertical shiplap on the overmantel.
Regular 1/2-inch drywall is a common cover for an overmantel frame. Use cement board under natural stone or large-format tile. Paper-faced drywall and wood are combustible, so keep them out of the clearance zone.
For outside corners, use stone veneer corner pieces or mitered, trimmed tile edges.
Mantel options for a corner
Three common choices are:
- A three-sided angled or curved shelf that follows the front of the unit
- A straight shelf set across the angled face
- A shallow floating mantel, which still needs to meet the clearance rules
A shallow mantel is enough to hold a few frames and seasonal decor. Wood mantels and shelves are combustible, so keep them clear of the opening and follow the distances for the unit.
Layout and lighting around the corner
Don’t push the furniture flat against the walls. Angle accent chairs toward the corner, or float an L-shaped sectional so it faces the diagonal focal point. Another option is to put the TV on the adjacent wall at a 90-degree angle to the fire.
For sconces, place one on each side of the angled face. A picture light can highlight art above the mantel. For more on fixtures and placement, see fireplace lighting ideas. For seating distances, see furniture in front of a fireplace.
Safety before you cut or nail
Locate the flue and any vent pipe before you cut or nail into a chase or a build-out. Corner prefab units often vent through a framed chase. Class A chimney pipe usually needs about 2 inches of clearance to combustibles, but the listing for your unit sets the exact distance.
If the hearth is raised, it can be cut down only if the required noncombustible hearth extension remains.
Common mistakes
- Assuming a corner fireplace can’t be updated without demolition. Framing and finishing usually handle it.
- Assuming any insert will fit a prefab corner firebox. Inserts must be listed for that specific unit.
- Applying the masonry clearance rules to a prefab unit instead of its manual.
- Treating the chase as empty space you can cut into freely.
For more ideas across the whole fireplace, see fireplace makeover ideas.