If your gas fireplace remote stops working, check the batteries, the receiver switch and the pairing before you replace anything. The receiver, not the handset, is often the part at fault. Work through the steps in order, because the simple checks cover most cases.
Check the Handset Batteries
Most handsets take two or three AAA batteries or a 9-volt, depending on the brand. Use fresh alkaline batteries. Rechargeable cells at 1.2 volts can be too weak to send a reliable signal. Check for corroded or bent battery contacts, which can break the connection even with fresh batteries.
Check the Receiver Batteries and Switch Position
The receiver is the box that actually controls the valve. It often takes four AA batteries, and these drain faster because it’s always listening for a signal. Replace them with fresh batteries.
Next, look at the receiver’s slide switch. It has three positions: ON, REMOTE and OFF. The switch must be set to REMOTE for the handset to work. If it’s set to ON or OFF, the remote is blocked.
Receivers usually sit in the valve compartment or are mounted on the wall. Heat can damage them. If the receiver sits near the firebox, the heat can drain its batteries and damage the electronics. Keep it away from hot surfaces, as your manual directs.
Re-Pair the Remote and Receiver
Replacing batteries can sometimes break the link between the handset and the receiver. To re-pair:
- Set the receiver switch to REMOTE.
- Press and release the receiver’s LEARN (or program) button. A paperclip works for small buttons. Listen for a beep.
- Press the ON button on the handset within the window your manual gives. The time varies by brand and model.
- Wait for a confirming beep or series of beeps.
Pairing steps differ by brand. Common systems include Skytech, Mertik Maxitrol and Proflame. Follow your model’s instructions.
Reset a Locked-Out Control Module
Some control modules lock out after a fault. You may see a red and green light blinking inside the lower compartment. To clear it, slide the reset switch next to the light to OFF, then back to REMOTE, and listen for the ready beep. If that doesn’t work, cut power to the fireplace at the home’s circuit breaker for a short time, then restore it.
Heat, Range and Thermostat Mode
- Range. A handset typically works from about 20 to 30 feet. Walls, metal and other electronics can shorten that range.
- Thermostat mode. Some remotes read the room temperature at the handset. If the handset sits in a warm spot, the fireplace may not light.
- Child lock. Some remotes have a child lock that makes them appear dead.
- Pilot status. On a standing-pilot unit, the remote can’t light the burner unless the pilot is already lit.
Use the Manual Backup
If you need heat while you troubleshoot, you can usually run the fireplace without the handset. Set the receiver switch to ON, or use the valve knob or wall switch, if your unit has one. Follow the lighting steps in the manual, and don’t leave the unit running unattended.
When to Replace the Remote or Call a Technician
Replacement remote kits typically cost about $50 to $150, depending on the brand. Before you buy one, check the receiver. A new handset won’t fix a faulty receiver. Many people replace the remote when the receiver is the actual fault.
Call a qualified technician if you smell gas, if the pilot won’t stay lit, or if the receiver looks scorched or melted. Don’t keep trying to light a unit that smells of gas.
If the fireplace keeps running after you switch it off, read why a gas fireplace stays on when the switch is off. If the remote works but the fireplace won’t light, see why a gas fireplace won’t ignite. For a burning or melting smell from the receiver, check gas fireplace smells.