It depends on your water supply and drains. A standard gravity toilet on city water usually keeps working during an outage. On a private well, the pump needs power, so you may get only a flush or two before the well’s pressure tank runs dry. A toilet that drains through a sewage ejector or grinder pump should not be flushed during an outage, because the pit can overflow into the home.
Which Setups Can Flush During an Outage
- City water with a gravity drain. Water pressure usually holds, so the tank refills normally. Flushing usually works.
- Private well. The pump needs electricity. You may get a flush or two from the water already in the toilet tank and the well’s pressure tank, and then the toilet tank won’t refill until power returns.
- Septic with a gravity drain field. Flushing works normally.
- Pressure-assisted toilets. These run on water pressure and work as long as the pressure holds.
Ask your utility or water provider how they handle outages. Municipal sewer lift stations can also fail during a long, wide outage.
When Not to Flush
- Basement toilets with a sewage ejector or grinder pump. These depend on electricity. Without power, the pump won’t run, and flushing can push sewage back into the home.
- Upflush or macerating toilets. These need power to move waste and won’t work during an outage.
- Electric or smart toilets. Toilets with electronic flush controls won’t flush without power unless the manufacturer provides a manual override.
If a septic or sewer system uses a lift pump, limit flushing. Stop if the drains gurgle or start to back up.
How to Flush Without Power
If your toilet works on gravity and you have water, you can flush by hand:
- Pour water into the bowl. Pour about 1 to 1.5 gallons quickly and steadily into the bowl. Pouring slowly won’t start the siphon. Older toilets with larger tanks may need more.
- Or fill the tank. Pour water into the tank until it reaches its normal water line, then flush with the handle.
Use water you have stored or collected, and avoid drinking-water reserves if you can. Use the bathroom sparingly and flush less often. The old rule, “if it’s yellow, let it mellow,” still applies.
The number of flushes you get from one tank depends on the tank size. Don’t count on a fixed number.
Store Water Before a Storm
If a storm or outage is forecast, fill a few containers with water. A filled bathtub holds roughly 40 to 80 gallons, which can cover many flushes. Keep a bucket by the toilet, so you can pour water into the bowl or tank when you need it.
Your Gas Fireplace During an Outage
A gas fireplace can keep some heat going in an outage, but the type matters:
- Standing-pilot (millivolt) units run without house power. The thermopile makes the small current the gas valve needs, so the burner keeps working. Only the blower stops, and heat output can drop.
- Electronic (intermittent pilot) units need 120-volt power or battery backup to light. Without either, they won’t ignite.
Check your model before you rely on it in an outage. Our explainer on how gas log fireplaces work covers the ignition types in more detail.
Conserve Water and Watch the Drains
- Flush less often, and only when needed.
- Don’t flush paper towels, wipes or other items that can clog the drain. These block the system faster when water and power are short.
- Stop flushing if the drains gurgle or slow down.
- If the outage is long, follow the instructions from your utility or local water provider.