Clean gas fireplace glass only after it has cooled completely. Use a cleaner made for fireplace glass, not a household glass cleaner. Skip abrasive pads, steel wool and razor blades, since they can scratch the glass or its coating. Check the rope gasket before you put the glass back.
Before You Start
Turn the unit off with the wall switch or remote, and turn the valve knob to OFF. Let the pilot cool, then give the glass time to cool fully. Glass can exceed 500°F during operation, and it can take an hour or more to cool.
Wear gloves. The glass is heavy, and its edges can chip.
Remove the Glass Safely
Most units hold the glass frame with spring clips or latches, often at the top and bottom. Some frames are held with screws instead.
- Remove the decorative grilles or louvers, if your model has them.
- Release the clips or remove the screws.
- Tilt the frame and lift it out.
- Lay it flat on a towel, carpet or padded table so it doesn’t scratch or chip.
Take a photo of the layout before you remove anything. It helps when you reassemble the unit.
Clean Both Sides
Use a cream cleaner made for gas fireplace glass, applied with a soft cloth or paper towel. Clean the inside of the glass as well as the outside, since the inside gets the film from combustion.
Dry the glass thoroughly and buff it until it’s streak-free. Some glass has a reflective or low-E coating, and abrasives can damage it.
Haze vs. Soot
A thin white haze is a mineral and sulfur deposit from combustion. It’s normal, but it bakes on and etches the glass if you leave it too long. Clean it regularly.
Black soot is different. Soot on the glass is not normal. It points to a combustion or log-placement problem. Cleaning the glass won’t fix the cause, so have a technician check the burner, the logs and the venting. Our guide to gas fireplace flame problems lists the usual causes.
Check the Gasket
The rope gasket around the glass seals the firebox. On direct-vent units, the seal keeps combustion air and exhaust separated from the room. Check that the gasket is intact and sits in its groove. Replace it if it is frayed, torn or unseated.
Put It Back Together and Relight
- Set the glass back into the frame, and seat it in the gasket.
- Secure all clips or screws, and reattach the grilles or louvers.
- Turn the gas back on, and relight the unit following the manual.
- Check that the latches are locked before you run the flames.
If the pilot won’t light after the glass is back in, see why a gas fireplace won’t ignite.
What to Avoid
- Ammonia-based or household glass cleaners. These can cloud or etch ceramic glass and leave a residue that bakes on.
- Abrasive powders, scouring pads and steel wool. These scratch the glass.
- Razor blades or scrapers. Some glass coatings scratch easily.
- Running the fireplace with the glass cracked, chipped, open or missing.
How Often to Clean
Clean the glass every few months during heavy use, or whenever haze appears. Between cleanings, check the glass for cracks, chips and gasket damage.
A professional annual service includes a gasket check, and the technician can tell you if the glass needs replacing. Cracked glass is a reason to stop using the unit until it’s repaired. For safety with a fireplace that’s been running with damaged parts, see our guide to carbon monoxide risk and detectors.