Wood Fireplace Use and Safety

Creosote in Your Chimney: How It Forms and How to Remove It

Creosote is condensed wood smoke that builds up in the flue and can ignite. Learn how it forms, the three stages, when to sweep and why removal needs a pro.

On this page
  1. Short answer
  2. How creosote forms
  3. The three stages
  4. How to check and when to sweep
  5. How creosote is removed
  6. Prevention

Short answer

Creosote is a tar-like residue left by wood smoke. It forms when smoke cools inside the flue and condenses on the walls. Sweep it when it reaches about 1/8 inch. Glazed creosote, the hardest kind, needs professional removal. Creosote is a fire hazard, so it should not be left to build up.

How creosote forms

Smoke from burning wood contains water vapor, unburned volatiles, tar and soot. When the flue gases cool to roughly 250°F or below, these condense on the cooler flue walls. The deposit then builds up layer by layer.

Several habits speed this up:

  • burning wet or unseasoned wood
  • smoldering or air-starved fires
  • oversized flues, which let smoke cool before it leaves
  • cold exterior chimneys
  • long, poorly insulated connector runs on a wood stove

The three stages

  • Stage 1: dry, flaky soot. It brushes off fairly easily. Even at this stage, it should be removed on a regular schedule. It is not harmless, and it can turn into harder deposits.
  • Stage 2: crunchy, tar-like black flakes. These are harder to brush off, and they sometimes need rotary tools.
  • Stage 3: a glazed, shiny, tar-like coating. It is very flammable, and it needs chemical treatment or rotary removal by a professional.

How to check and when to sweep

Shine a flashlight up the flue with the fire out and the firebox cold. Scrape a small area of the liner with a fireplace tool, wearing gloves and eye protection. If the deposit is about 1/8 inch thick, which is the CSIA guidance point, it is time for a sweep. Any glazed (stage 3) deposit calls for immediate professional cleaning.

A stovepipe thermometer can help with a wood stove. Gauges vary, but a usable working range is roughly 250 to 475°F. Readings well below that point toward creosote, and readings far above it can mean the stove is overfired.

How creosote is removed

  • Sweeping. Use brushes sized to the flue. Wire brushes suit masonry, and poly brushes suit stainless liners. Rods can be run from the top or the bottom.
  • Stage 3 deposits. A professional may use chemical treatments, followed by sweeping, or rotary chain or whip tools. Chain tools can damage clay tiles and liners, so they are best left to professionals.
  • Creosote logs and powders. These loosen stage 1 and 2 deposits only. You still need a sweep afterward. They are not a substitute for a sweep.
  • Protection. Wear a respirator and eye protection. Creosote irritates the skin, and it is considered a probable carcinogen, so keep contact to a minimum.

Do not try to burn out creosote with a very hot fire. That can start a chimney fire. For the signs that a flue needs attention, see what are the signs of a dirty chimney.

Prevention

The complete guide to wood fireplace use and safety

Wood Burning Fireplace Tips: Using and Maintaining Your Fireplace
Read the guide

Keep exploring

Guides from other topics

All topics →