Wood Fireplace Use and Safety

Does a wood burning stove need a flue?

Yes. Every wood stove needs a flue and chimney to vent smoke and carbon monoxide outdoors. Here is what the flue, connector and chimney must meet.

On this page
  1. Short answer
  2. What counts as a flue
  3. Chimney options: masonry or factory-built
  4. Inserts and liners
  5. The connector (stovepipe)
  6. Height and draft
  7. Common mistakes

Short answer

Yes. Every wood stove needs a flue and a chimney to carry smoke and carbon monoxide outside the house. There is no safe ventless wood stove for home heating. The flue is the passage inside the chimney that carries the exhaust out.

What counts as a flue

The flue is the enclosed channel that moves combustion gases from the stove to the outdoors. A stove connects to the flue through a stovepipe, which is called the connector. The connector alone is not a chimney, and it cannot be run through a ceiling and out into the open air.

Chimney options: masonry or factory-built

  • A masonry chimney with a suitable liner. The liner must be appropriate for wood burning and sized for the stove.
  • A listed factory-built chimney. Look for a Class A chimney listed to UL 103HT, installed exactly to its listing.

Whichever you use, the chimney must be in good condition. An old, unlined masonry chimney is not automatically usable, even if it was once used for a fireplace.

Inserts and liners

If you install a fireplace insert, NFPA 211 calls for at least a positive connection from the insert to the flue liner, and most insert listings and chimney professionals call for a full liner from the insert to the top of the chimney. Stainless steel liners are often insulated or wrapped, and the requirements depend on the liner’s listing. Follow the listing for your product.

The connector (stovepipe)

  • Material: single-wall black steel, usually at least 24 gauge (22 gauge is common), or a listed double-wall pipe.
  • Clearance: single-wall connectors generally need 18 inches of clearance to combustibles. Listed double-wall pipe often needs less, typically about 6 inches, but check the listing.
  • Joints: install crimped ends pointing toward the stove, and use three sheet-metal screws per joint.
  • Slope: a horizontal run should rise at least 1/4 inch per foot.
  • Length: a horizontal run should not be longer than 75 percent of the chimney height above the connector (NFPA 211).
  • Size: match the stove’s flue collar diameter. Never reduce it.
  • Penetrations: the connector must not pass through a wall, floor or ceiling without a listed thimble or pass-through.

Height and draft

The chimney must meet the 3-2-10 rule. Many stove manufacturers also specify a minimum system height, often around 14 to 16 feet, though this varies by model.

Do not oversize the flue. A flue that is too large for the stove can draft poorly and build up creosote. Do not share a flue with another appliance unless the code and the listings allow it.

Common mistakes

  • Using a gas vent. A gas B-vent is not a wood stove flue.
  • Treating stovepipe as a chimney. Stovepipe cannot carry smoke through a ceiling to the outside.
  • Assuming an old chimney is fine. Have it inspected and, if needed, relined.
  • Skipping the permit. Get a permit and an inspection. Insurers often require them.

Once the stove is installed, place carbon monoxide alarms near it, and keep them working. For how CO gets into a home, see can a wood burning fireplace cause carbon monoxide poisoning. For chimney clearances and code, see fireplace chimney requirements.

The complete guide to wood fireplace use and safety

Wood Burning Fireplace Tips: Using and Maintaining Your Fireplace
Read the guide

Keep exploring

Guides from other topics

All topics →