Wood Fireplace Use and Safety

When to Close the Fireplace Damper (and When to Keep It Open)

Keep the fireplace damper fully open while a fire burns, and close it only when the fire and embers are completely out. Here is how to tell when it is safe.

On this page
  1. Short answer
  2. Why closing too early is dangerous
  3. How to tell when the fire is fully out
  4. Types of dampers
  5. Special cases: gas logs and wood stoves
  6. Other damper checks

Short answer

Open the damper fully before you light the fire, and keep it fully open while the fire burns. Close it only after the fire is completely out, with no glowing embers and no smoke. That is often the next day, not right after the flames die down.

Why closing too early is dangerous

Closing the damper over smoldering embers traps smoke and gases in the flue. Those gases, including carbon monoxide, can then flow back into the room. Closing the damper does not put the fire out, and it does not hold heat in while the fire is still active.

Partly closing the damper to slow a wood fire is also a bad idea. It raises the risk of smoke spilling into the room and of creosote building up in the flue. Use the air controls on a stove, or the size of the fire, to manage burning rather than the damper.

Once the fire is fully out, an open damper lets warm room air escape up the chimney, much like an open window. That is the reason to close it at the right time.

How to tell when the fire is fully out

Wait until the fire and ashes are cold. Embers can stay hot under the ash for many hours. Many people wait overnight or longer before closing.

Before closing, check that:

  • there are no flames, glowing embers or visible smoke
  • the ash has cooled completely
  • the firebox looks clear of hot coals when you look in with a flashlight

If you are unsure, leave the damper open and wait longer.

Types of dampers

  • Throat dampers sit just above the firebox, and they are usually cast iron. They often seal poorly, and they can warp or rust over time.
  • Top-sealing dampers sit at the top of the chimney. They seal better than throat dampers, and some models double as a chimney cap. A professional can install one.

To find the position, look at the handle, lever or chain. A flashlight beam or a light draft on your hand can confirm whether the damper is open.

Special cases: gas logs and wood stoves

  • Vented gas logs: the damper must be permanently fixed open, using a damper clamp, as the manufacturer and local code require (NFPA 54 is the reference). Never close it on a gas appliance.
  • Wood stoves with a pipe damper: follow the manual. Most modern EPA-certified stoves control the burn with their air settings, not with the damper.

If cold air pours down the chimney when you open the damper, prime the flue by holding a lit, rolled piece of newspaper near the damper for a few seconds before you light the fire.

Other damper checks

  • Inspect the damper every year for rust, warping and a full seal. A damper that does not seal wastes heat all winter.
  • If smoke comes into the room while the fire is burning, stop and check the damper position, the flue and the draft. Smoke in the room does not always mean the damper is closed. It can also mean negative house pressure or a blockage.
  • A damper that is hard to move or stuck open or closed should be repaired before the next fire.

For the full process of putting a fire out, see how to put out a fireplace fire safely. For the carbon monoxide side of damper use, see can a wood burning fireplace cause carbon monoxide poisoning.

The complete guide to wood fireplace use and safety

Wood Burning Fireplace Tips: Using and Maintaining Your Fireplace
Read the guide

Keep exploring

Guides from other topics

All topics →